To Do

This is just a list of stuff we feel we need to do at some point. This page is really for personal use but I know it may be interesting to some people:

1. Clean sails and sail covers
2. Disassemble port side cockpit Barient #26 Winch Cleaned and lubed. Spins great now.
3. Choose and install Inverter Magnum MS2812 up and running
4. Drop dingy, test for leaks and test ride it Cleaned it and it works great!
5. Run GPS 12v cable permanently
6. Buy and install wifi solution Done. If I had hair I would have pulled it all out!
7. Replace forward hatch rubber seal and clean
8. Change engine oil After the trip to Florida – Been done recently
9. Test fit and start Honda 2000i Generator to the shore power input
10. Re-certify Fire extinguishers Replaced with new where needed
11. Test Alcohol Stove
12. Write up visible waste management plan Written,Printed and Laminated
13. Mount anchor Test mounted
14. Tighten Mizzen stays Previous owner said no need :)
15. Sand & varnish bright work (ongoing job)
16. Inspect all extra sails
17. Fill water tanks filled and figured out
18. Purchase new handheld VHF Bought Standard Horizon HX851
19. Run/Start Westerbeke 4-107 Started right up and ran smooth
20. Add Depth Marks to chain Marked at 50ft, 75ft, 100ft, 125ft – 140ft overall
21. Build/Install Jack lines
22. Clean Bimini Done and waterproofed
23. Repair Manual Whale Gusher 10 Bilge Pump
24. Build Anchor Trip Line
25. Build Anchor Snubber/Bridle
26. Install Solar Panels 2 x 145watt Kyocera Panels
27. Start Dinghy Motor – Fired right up! Spins like a top. Old Evinrude 4.5

Be Sociable, Share!

Leave a Reply

Your email address will not be published. Required fields are marked *